I just clean nozzle of extruder and when i fix it back the temperature stop raising.
i verified the heaters its fine but still when i put heater back to the printer it will not work.
Please some one advise me on this issue
My whats-app number is +966597733640 please send me your suggestion.
Dear asim ali,
Is the thermistor connector tightly in its place? As well, is your software reading the room temperature or is it showing 0 C; do you see in the "Communication" tab any M999 error; when heating the extruder, does the led from the electronic board corresponding to the E0/E1 (whichever you have the problem with) thermistor mosfet light up?
Please request a firmware download via the Ticket System