Hello and thank you for choosing the Creatr HS for your printing needs.


This solution is to show you a example of  a possible error which can appear on the HS stand alone display and how to fix it.


The olimex board which controls the function of the stand  alone display does not boot up properly or gives the type of error you see in the picture below, it could be that the software image stored on the SD card found in the olimex got corrupted and has to be reflashed;



To that end we kindly ask that you follow the instructions in the link below and reflash the software image on the olimex board;


How to Upload the Creatr HS Software Image to a SD Card


If the issue is still present after reflashing the image on the SD card please make sure to open a ticket on our support page and a Leapfrog support agent will help you further.


We thank you for checking out our Leapfrog 3D Printer technical support solutions online! If you were unable to fine a solution in our database, please feel free to open a new support ticket by clicking the following link: I want to open a new support ticket.