Repair Instructions

Software solutions focusing on the Leapfrog Creatr HS 3D Printer and Simplify3D

Replacement head fans
In this solution you will be instructed on how to change your Creatr HS/ HS XL/ HS Lite printhead fans.          Tools:     To change the fans yo...
Tue, 10 Mar, 2020 at 11:39 AM
How to Install, Repair, or Replace the (Flexible) Filament Gland
Applies to Creatr HS Printers needing to print Flexible Filaments If you have recently purchased a flexible filament gland to use w...
Mon, 4 Apr, 2016 at 1:08 PM
How to Calibrate the Z-Offset of the Creatr HS
Estimated Time for First-Time Users (without other solution links): 20-30 minutes Tools needed: 10mm wrench key, size 2 Allan Key !!WARNING! NOT FO...
Mon, 15 Feb, 2016 at 11:42 AM
Why is My Creatr HS not Connecting to My PC?
Hello and thank you for choosing the Creatr HS for your printing needs. In the following solution you will be instructed on how to connect you Creat...
Thu, 7 Apr, 2016 at 9:14 AM
How to Replace Your Creatr HS Heated Bed
Hello and thank you for choosing the Creatr HS for your printing needs. In the following solution you will be instructed on how to replace your Crea...
Mon, 4 Apr, 2016 at 1:09 PM
How do I Change the Power Source Voltage on My Creatr HS?
Hello and thank you for choosing the Creatr HS for your printing needs. If the region you are situated in requires you to move the power output of y...
Thu, 7 Apr, 2016 at 9:19 AM
How to Replace the Y Bearings on Your Creatr HS Printer
The following solution will instruct you on how to properly clean and prepare your Creatr HS Y bearings. Tools: a number 2 , 4 and 5...
Wed, 9 Mar, 2016 at 9:13 AM
Replacing the Electronics Assembly on the Creatr HS Printer
Hello and thank you for choosing the CreatrHS for your printing needs.   The following solution will instruct you on how to replace the electronics as...
Thu, 10 Dec, 2015 at 1:51 PM
Why are My Y-Axis Stepper Motors not Working?
Hello and thank you for choosing the Creatr HS for your printing needs. If one of your Y stepper motor is not working we would ask you to check t...
Thu, 7 Apr, 2016 at 9:22 AM
How to Check the Functionality of the X and Y Stepper Motors - Creatr HS Series
Hello and thank you for choosing the Leapfrog Creatr HS series printer for your 3D printing needs.   This solution applies to the Creatr HS, Creatr H...
Wed, 6 Apr, 2016 at 12:29 PM

User Manuals

Quick Start Guide

Print Settings

Demo Print Downloads

Drivers Downloads

Slicer Software

User Manuals

Firmware Downloads

Creatr HS Video Library